3D printed clock hands that fit well a Ф30cm dial.
- Hour hand total length: 75mm - Minute hands total length: 122mm - Seconds hand is not included but a pin is included - you should glue the pin on top of the minute hands in order to cover the clock mechanism shaft
Use XY Hole Compensation parameter to adjust the holes of the hands so that they fit spot on when printed on different printers. The two holes are 3mm (minute hand) and 5mm (hour hand). I have included two small models for testing the holes size and if they don't fit, then you need to adjust your XY Hole/Contour Compensation in your slicer software.
Printed at 0.12mm layer height and slow speeds (10-30mm/s for initial layers and ~100mm/s for the rest)
1.25g of filament to print a set of hands (includes minute and hour hands and a pin for the seconds)
One man's work, not AI. I am Dimitar - a maker at heart and a craftsman in real life. I have been making whatever I could put my hands on since I can remember. In 2012 I started making articulated desk lamps using linden wood and this lived to become something much bigger than I was hoping for. Eventually inventing and making lamps and clocks among many other things became my full time job. Now I am a designer, a woodworker and maker of things. But mostly, an explorer.
Избирането на селекция води до пълно опресняване на страницата.
